Belt tensioning wheel

The idler unit is a tensioning system for belt drive and idler unit

Increase the wrap angle of the belt drive

Therefore, it can support higher power levels or allow the use of smaller units

Belt tension caused by compensation operation

Allow shorter center distance

Reduce wear on belt drives

The ready-made components include riveted deep stamping, half section of profiled steel plate pulley, and deep groove ball bearings. The larger diameter pulleys also need to be welded together. The guide angle on the contour of the pulley can prevent belt damage. Due to the steel plate structure, the additional rotational mass and unbalanced mass generated are very low.

A type is suitable for V-belts, B type is suitable for flat belts, V-belts, and round belts, and D type is suitable for round belts, steel cables, and hemp ropes.